The Enclosed Dash Logger (EDL3) is a combined fully programmable data logger and powerful control device in one lightweight unit.

Based on the ADL3, it is supplied in an enclosed unit providing the flexibility to connect a display suitable for your application or to use as a 'black box' type data logger. It provides all the advanced features of MoTeC's ADL3 Dash Logger, including warning alarms, lap times, fuel calculations, minimum corner speeds, maximum straight speeds and more.

The EDL3 performs calculations, acquiring data from other MoTeC devices such as an ECU, Dash Logger and VIMs, which enable it to log more than 300 inputs, including high resolution sensor inputs.

• Suitable for bikes, cars, marine and industrial applications
• Supports Wideband Lambda from MoTeC PLMs or LTCs
• Easily integrates with MoTeC CAN based products such as ECUs, expanders, lap timing devices and shift lights
• More than 300 sensor inputs, using VIM input expanders
• GPS Lap Timing
• Tell Tales
• Diagnostic Logging
• Preserved Channels
• Running Min/Max, Timers, PID Control, Telemetry, Engine Log

• Standard Ethernet cable
• 61213 – ADL3 loom
• 61131 – Ethernet cable, unterminated, 2 metre

• Data Logging: Increases internal logging memory to 250 MB
• Pro Analysis: Provides access to advanced i2 Pro data analysis software
• Telemetry: Enables transmission of live data from the vehicle
• Remote Logging: Enables converting telemetry data into a log file
• 52 I/O: Provides additional input/output functionality consisting of:
  • 14 extra Analogue voltage inputs (AV11 to AV24, see pinout)
  • 4 extra Analogue temperature inputs (AT5 to AT8, see pinout)
  • 4 extra Auxiliary outputs (AUX5 to AUX8, see pinout)

Windows-based software designed for setup and management of the display* and data logging* system, that provides:

• Configuration of the inputs, ouputs, LEDs*, display*, data logging* and calculations
• Offline generation of a configuration file that can then be sent to the device.
• Channel monitoring
• Firmware updating and extensive help screens

* Where applicable based on the device.

Dimensions are in mm. Ensure product is not stressed when mounted.

When using an M4, M48 or M8 ECU, the should be connected via RS232. For some ECUs, a PCI cable may also be required.

The Display Logger should be connected via the CAN bus when using a ‘hundred series’ ECU(M400/M600/M800/M880) or M84, and any number of other CAN devices. See the following example.

Detailed wiring information is available in the user manual at www.motec.com/downloads.

Mating connector: Part number 68086